Motor Driver Controller - RED

Motor Driver Controller - RED

 
$24.95
1095
In stock
+
Add to wish list
This Dual H-Bridge Motor Driver Shield, which based on H-bridge driver Chip L298N Motor Driver Integrated Circuit, is a usefull module for controlling of robotics and mechanics. It can drive two brushed DC motors or one 4-wire two-phase stepper motor. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors.Both motors can be driven simultaneously while set to a different speed and direction. All driver lines are diode protected from back EMF. Features Light weight, small dimension Super driver capacity FWD protection Heavy load Heat sink Power selection switch 4 pull up resistor switch 2 DC motor/ 4 coil dual phrase stepper motor output Motor direction indication LED 5V power indication LED 4 standard mouting holes Specifications Driver: L298N Driver power supply: +6V~+35V Driver peak current: 2A Logic power output Vss: +5~+7V (internal supply +5V) Logic current: 0~36mA Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss Max drive power: 25W (Temperature 75 ℃) Working temperature: -25℃~+130℃ Dimension: 60mm*54mm Driver weight: ~48g